LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1439 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Upper Retaining Bolts To Back Of Rear Fascia
    GM743498Courtesy of GENERAL MOTORS CORP.
  1. Position the fascia to the vehicle impact bar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the upper retaining bolts to the fascia.

    Tighten:  Tighten the bolts to 2.5 N.m (22 lb in).

  3. Install the screws that retain the fascia to the wheelhouse flanges.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    Fig 2: Installing Rear Wheelhouse Flange Screws
    GM743499Courtesy of GENERAL MOTORS CORP.
    4. Fig 3: Installing Lower Rear Fascia Push-Pins
    GM743497Courtesy of GENERAL MOTORS CORP.
  4. Install and fully seat the lower push-pins.
  5. Install the backup lamp socket assemblies, if applicable. Refer to Backup Lamp Replacement (GMC) in Lighting Systems.
scientia non olet · About LEMON Manuals