Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Front Bumper Fascia (TrailBlazer)

Courtesy of GENERAL MOTORS CORP.

Position the fascia to the vehicle, ensuring that the body side attachment tabs are fully seated.
Install the 4 push-pins that retain the bottom of the fascia to the headlamp housing panel.
Install the push-pins (3) that retain the fascia to the fascia support rods (2).

Fig 2: View Of Fascia-To-Fascia Support Rod Push-Pins
Courtesy of GENERAL MOTORS CORP.
Install the air defector. Refer to Air Deflector Replacement - Front Bumper Fascia .
Install the fog lamps. Refer to Fog Lamp Replacement - Front (Rainier) , Fog Lamp Replacement - Front (Bravada) or Fog Lamp Replacement - Front (Envoy, Envoy XUV, TrailBlazer) in Lighting Systems.
Lower the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 3: Installing Fascia-To-Headlamp Housing Panel Bolts & Push-Pins

Courtesy of GENERAL MOTORS CORP.

Install the 2 bolts that retain the top of the fascia to the headlamp housing panel.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Install the push-pin that retains the center of the top of the fascia to the headlamp housing panel.
Install the grille. Refer to Grille Replacement (Envoy, Envoy XUV) , Grille Replacement (TrailBlazer) , Grille Replacement (Bravada) or Grille Replacement (Rainier) in Exterior Trim.