LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1438 (Frame & Underbody) >> Repair Instructions >> Tow Hook Replacement - Front (Chevrolet (X88) ONLY) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Tow Hook To Impact Bar
    GM742128Courtesy of GENERAL MOTORS CORP.
  1. Install the tow hook to the impact bar, ensuring that the locating pin is properly indexed to the impact bar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolt which retains the tow hook to the impact bar.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the impact bar. Refer to Impact Bar Replacement - Front Bumper in Bumpers.
  4. Install the fascia. Refer to Fascia Replacement - Front Bumper (Rainier) , Fascia Replacement - Front Bumper (Bravada) , Fascia Replacement - Front Bumper (Envoy, Envoy XUV) or Fascia Replacement - Front Bumper (TrailBlazer) in Bumpers.
  5. Install the grille. Refer to Grille Replacement (Envoy, Envoy XUV) , Grille Replacement (TrailBlazer) , Grille Replacement (Bravada) or Grille Replacement (Rainier) in Exterior Trim.
scientia non olet · About LEMON Manuals