Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Properly support the frame when you change the body mounts. If only one mount is changed, lower the entire side on which the mount in placed in order to provide clearance for the mount.

Fig 1: Removing Lower Cushion From Radiator Support

Courtesy of GENERAL MOTORS CORP.

Raise the vehicle slightly on a hoist. Refer to Lifting and Jacking the Vehicle in General Information.
Place jack stands under the body on the side of the vehicle that the mounts will be placed.
Remove the body mount bolt, retainer, and lower cushion (1) from the radiator support.

Fig 2: Removing Remaining Frame Lower Cushions

Courtesy of GENERAL MOTORS CORP.

Remove the body mount bolts, retainers, and lower cushions (1) from the 5 other mount locations.
Lower the hoist enough in order to leave the body supported by the jack stands.
Remove the upper cushions (2) from the vehicle.