LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1438 (Frame & Underbody) >> Repair Instructions >> Crossmember Replacement - Rear Steering Gear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Steering Gear Crossmember
    GM759216Courtesy of GENERAL MOTORS CORP.
  1. Install the rear steering gear crossmember to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the rear steering gear crossmember mounting bolts.

    Tighten:  Tighten the rear steering gear crossmember mounting bolts to 50 N.m (37 lb ft).

  3. Install the front steering gear crossmember rear mounting bolts.

    Tighten:  Tighten the front steering gear crossmember mounting bolts to 50 N.m (37 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals