LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1438 (Frame & Underbody) >> Repair Instructions >> Crossmember Replacement - Front Steering Gear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Steering Gear Crossmember Mounting Bolts
    GM687452Courtesy of GENERAL MOTORS CORP.
  1. Install the steering gear crossmember.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the steering gear crossmember mounting bolts.

    Tighten:  Tighten the steering gear crossmember mounting bolts to 50 N.m (37 lb ft).

    3. Fig 2: Installing Rear Lower Control Arm Bracket To Frame Mounting Bolts
    GM899003Courtesy of GENERAL MOTORS CORP.
  3. Install the rear lower control arm bracket to frame mounting bolts.

    Tighten:  Tighten the rear lower control arm bracket to frame mounting bolts to 240 N.m (177 lb ft).

    4. Fig 3: Removing/Installing Engine Shield
    GM687450Courtesy of GENERAL MOTORS CORP.
  4. Install the engine shield.
  5. Install the engine shield mounting bolts.

    Tighten:  Tighten the engine shield mounting bolts to 25 N.m (18 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals