LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Rocker Molding Scuff Plate Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear door.
    2. Fig 1: Removing Rocker Molding Scuff Plate - Rear
    GM750775Courtesy of GENERAL MOTORS CORP.
  2. Remove the push-pin that retains the rear rocker molding scuff plate to the rocker panel.
  3. Lift upwards on the scuff plate to release the retaining tabs.
  4. Remove the scuff plate from the vehicle.
scientia non olet · About LEMON Manuals