LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Rocker Molding Scuff Plate Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rocker Molding Scuff Plate - Rear
    GM750775Courtesy of GENERAL MOTORS CORP.
  1. Position the scuff plate to the rocker panel.
  2. Apply downward pressure on the scuff plate to seat the retaining tabs.
  3. Install the push-pin that retains the scuff plate to the rocker panel.
  4. Close the rear door.
scientia non olet · About LEMON Manuals