LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Window Reveal Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Window Reveal Molding - Endgate
    GM1204239Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear wiper arm. Refer to Wiper Arm Replacement - Rear (TrailBlazer, Envoy) or Wiper Arm Replacement - Rear (XUV) in Wipers/Washer Systems.
  2. Remove the screws (2) retaining the endgate window reveal molding assembly (1) to the endgate.
  3. Slide the molding assembly rearward, then upward to release the molding retainers from the endgate.
  4. Disconnect the electrical connector for the high mounted stop lamp.
  5. Remove the high mounted stop lamp from the molding. Refer to High Mounted Stop Lamp Replacement (Envoy, TrailBlazer, Rainier, Bravada) or High Mounted Stop Lamp Replacement (Envoy XUV) in Lighting Systems.
scientia non olet · About LEMON Manuals