LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Window Reveal Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Window Reveal Molding - Endgate
    GM1204239Courtesy of GENERAL MOTORS CORP.
  1. Install the high mounted stop lamp to the endgate window reveal molding (1). Refer to High Mounted Stop Lamp Replacement (Envoy, TrailBlazer, Rainier, Bravada) or High Mounted Stop Lamp Replacement (Envoy XUV) in Lighting Systems.
  2. Connect the electrical connector for the high mounted stop lamp.
  3. Install the molding assembly to the endgate by inserting the retainers to the slots in the endgate panel and sliding the molding forward.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws (2) retaining the molding to the endgate.

    Tighten:  Tighten the molding screws to 3 N.m (27 lb in).

  5. Install the rear wiper arm. Refer to Wiper Arm Replacement - Rear (TrailBlazer, Envoy) or Wiper Arm Replacement - Rear (XUV) in Wipers/Washer Systems.
scientia non olet · About LEMON Manuals