LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel Rear >> Removal Procedures

Removal Procedures

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Rocker Panel Molding - Rear
    GM831869Courtesy of GENERAL MOTORS CORP.
  1. Remove rocker panel assembly. Refer toMolding Replacement - Rocker Panel (TrailBlazer EXT, Envoy XL)  or Molding Replacement - Rocker Panel (TrailBlazer, Envoy, Bravada)  .
  2. Remove the door opening screws (1) from front of rocker panel rear molding.
  3. Release push-in retainers (2) using a trim removal tool.
    4. NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
  4. Remove the rocker panel molding from the rocker panel.
scientia non olet · About LEMON Manuals