LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rocker Panel Molding - Rear
    GM831869Courtesy of GENERAL MOTORS CORP.
  1. Position the rocker molding to the holes in the rocker panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the door opening screws (1).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  3. Install push-in retainers
scientia non olet · About LEMON Manuals