LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Front  .
  2. Remove the rear rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Rear  .
  3. Remove the assist step. Refer to Assist Step Replacement in Frame and Underbody.
    4. Fig 1: Removing Rocker Panel Molding (TrailBlazer, Envoy, Bravada)
    GM742127Courtesy of GENERAL MOTORS CORP.
  4. Remove the rocker panel molding bolts located at each end of the rocker panel molding.
  5. Use the J 36796  in order to remove the 7 push-pins that retain the bottom of the rocker panel molding to the body.
  6. Remove the rocker panel molding from the vehicle.
scientia non olet · About LEMON Manuals