LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rocker Panel Molding (TrailBlazer, Envoy, Bravada)
    GM742127Courtesy of GENERAL MOTORS CORP.
  1. Position the rocker panel molding to the body.
  2. Install the 7 push-pins that retain the bottom of the rocker panel molding to the body.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the rocker panel molding bolts located at each end of the rocker panel molding.

    Tighten:  Tighten the rocker panel molding bolts to 7 N.m (62 lb ft).

  4. Install the assist step. Refer to Assist Step Replacement in Frame and Underbody.
  5. Install the front rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Front  .
  6. Install the rear rocker molding scuff plate. Refer to Rocker Molding Scuff Plate Replacement - Rear  .
scientia non olet · About LEMON Manuals