Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Door Sill Plates To Top Of Rocker Molding (TrailBlazer EXT, Envoy XL)

Courtesy of GENERAL MOTORS CORP.

Position rocker molding to the holes in the rocker panel.
Install door sill plates on top of rocker molding, ensuring that the retaining tabs are thoroughly engaged.

Fig 2: Installing Rocker Panel Molding (TrailBlazer EXT, Envoy XL)

Courtesy of GENERAL MOTORS CORP.

Install upper push-in retainer (1), pressing into place until fully seated.
Install the push-in retainers (3) in the bottom of the rocker molding.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rocker molding screw (2) to the rocker molding.
Tighten: Tighten the screw to 6 N.m (53 lb in).