LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Wheel Opening >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Wheel Opening Molding
    GM752099Courtesy of GENERAL MOTORS CORP.
  1. Ensure the painted body surface in the tape contact area is clean and dry.
  2. Warm body panel with a heat lamp or heat gun if necessary, to a temperature between 18.8-41.1°C (66-100°F).
  3. Remove the tape liner from the adhesive tape.
    IMPORTANT: Do not touch the adhesive surface.
  4. Ensure that the molding is aligned with the body panel. Press the wheel opening molding to the body panel.
  5. Hand roll the wheel opening molding to the body in order to ensure proper adhesion.
scientia non olet · About LEMON Manuals