LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Panel >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Panel Molding
    GM741241Courtesy of GENERAL MOTORS CORP.
  1. Install the trim to the tail lamp, ensuring that the retaining tabs are fully seated.
  2. Install the tail lamp assembly to the vehicle. Refer to Tail Lamp Replacement in Lighting Systems.