LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Door Body Side (Bravada, Rainier) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Rear Door Body Side Molding (Bravada, Rainier)
    GM752103Courtesy of GENERAL MOTORS CORP.
  1. Remove the molding from the vehicle using the following procedure:
    1. Heat the door side molding using aJ 25070  . See Special Tools and Equipment  . Hold the heat gun approximately 152 mm (6 in) from surface.

      Apply heat using a circular motion for about 30 seconds.

      IMPORTANT: Be careful not to scratch or chip the paint.
    2. Peel the door side molding from the panel surface using a flat-bladed tool.
  2. Remove all adhesive from the body panel and the back of the door side molding using a 3M(tm) Scotch Brite molding adhesive remover disk 3M(tm) P/N 07501 or equivalent.
  3. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
scientia non olet · About LEMON Manuals