Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Front Hood Molding (Rainier)

Courtesy of GENERAL MOTORS CORP.

Align the retaining tabs on the hood molding (1) with the slots in the front of the hood.
Press the hood molding into place until the retainers are fully seated.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Close the hood.