LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Hood Front (Envoy, Envoy XUV, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Front Hood Molding (Envoy, Envoy XUV, Bravada)
    GM742126Courtesy of GENERAL MOTORS CORP.
  1. Align the retaining tabs on the hood molding with the slots in the front of the hood.
  2. Press the hood molding into place until the retainers are fully seated.
  3. Close the hood.
scientia non olet · About LEMON Manuals