Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure the painted fender surface in the tape contact areas are clean and dry.
- Position the front wheel opening molding to the front fender.
- Install the locating push-pin (1) into the molding.
- Install the remaining 5 push-pins in order to secure the molding to the fender.
- Warm the body panel and molding using a heat lamp or a heat gun, if necessary to a temperature between 18.8-43.3°C (66-100°F).
- Remove the tape liner from the adhesive tape.
- Press the molding to the fender.
- Hand roll the molding to the fender in order to ensure proper adhesion.
IMPORTANT:
Do not touch the adhesive backing.