LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Exterior Trim) >> Repair Instructions >> Emblem Replacement - Grille (Envoy, Envoy XUV, TrailBlazer) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Grille Emblem (Envoy, Envoy XUV, TrailBlazer)
    GM754908Courtesy of GENERAL MOTORS CORP.
  1. Install the emblem to the grille.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the nuts that retain the emblem to the grille.

    Tighten:  Tighten the nuts to 3 N.m (27 lb in).

  4. Install the grille. Refer to Grille Replacement (Envoy, Envoy XUV)  , Grille Replacement (TrailBlazer)  , Grille Replacement (Bravada)  or Grille Replacement (Rainier)  .