Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transfer case right rear speed sensor.
Tighten: Tighten the speed sensor to 17 N.m (13 lb ft).
- Connect the transfer case right rear speed sensor electrical connector.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
NOTE:
Refer to Fastener Notice in Cautions and Notices.