LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Transfer Case - NVG 226-NP8) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement (GMC, Buick) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting/Connecting Control Switch Electrical Connector
    GM651279Courtesy of GENERAL MOTORS CORP.
  1. Install the electrical connector to the control switch.
    2. Fig 2: Installing Control Switch
    GM756018Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the control switch in the trim plate, a snap should be felt or heard.
  2. Install the control switch in the trim plate.
    3. Fig 3: Trim Plate - Instrument Panel (I/P) Accessory
    GM712822Courtesy of GENERAL MOTORS CORP.
  3. Install the trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC) or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile/Buick) in Instrument Panel, Gages, and Console.
    4. Fig 4: Identifying Console Assembly
    GM741613Courtesy of GENERAL MOTORS CORP.
  4. Install the floor console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals