LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Transfer Case - NVG 226-NP8) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Location Of Drive Shaft
    GM746665Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear propeller shaft. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft.
    3. Fig 2: Removing Rear Output Shaft Seal
    GM715670Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear output shaft seal.
    4. Fig 3: Removing Rear Output Shaft Bushing
    GM801274Courtesy of GENERAL MOTORS CORP.
  4. Inspect the rear output shaft bushing for scoring or wear.
  5. Remove the rear output shaft bushing, if required, using the J 45380  .
    1. Install the finger section of the J 45380  in front of the bushing.
    2. Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out.
    3. Using a wrench on the forcing screw, remove the rear output shaft bushing.
scientia non olet · About LEMON Manuals