LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Transfer Case - NVG 226-NP8) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front (TrailBlazer, Envoy, Rainier, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing J 45236 On Front Output Shaft
    GM765966Courtesy of GENERAL MOTORS CORP.
  1. Install the J 45236  on the front output shaft.
    2. Fig 2: Aligning Front Output Shaft Seal
    GM765968Courtesy of GENERAL MOTORS CORP.
  2. Align the front output shaft seal on the J 45236-2 (1).
  3. Using the J 45236-1 (2), install the front output shaft seal.
  4. Remove the J 45236-1 and the J 45236-2.
    5. Fig 3: Removing/Installing Dust Shield From Front Output Shaft
    GM747076Courtesy of GENERAL MOTORS CORP.
  5. Install the dust shield on the front output shaft.
  6. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  7. Inspect the transfer case fluid level. Refer to Transfer Case Fluid Replacement (TrailBlazer, Envoy, Rainier, Bravada)  or Transfer Case Fluid Replacement (TrailBlazer EXT, Envoy XL, Envoy XUV)  .
  8. Install the fuel tank shield, if equipped. Refer to Fuel Tank Shield Replacement (TrailBlazer, Envoy) or Fuel Tank Shield Replacement (TrailBlazer EXT, Envoy XL) in Frame and Underbody.
  9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals