LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Transfer Case - NVG 226-NP8) >> Repair Instructions >> Transfer Case Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Aligning Input Shaft Seal On Input Shaft
    GM747110Courtesy of GENERAL MOTORS CORP.
  1. Align the input shaft seal on the input shaft.
  2. Using the J 42738  , install the input shaft seal.
  3. Install the transfer case assembly. Refer to Transfer Case Assembly Replacement (TrailBlazer, Envoy)  .
  4. Inspect the transfer case fluid level. Refer to Transfer Case Fluid Replacement (TrailBlazer, Envoy, Rainier, Bravada)  or Transfer Case Fluid Replacement (TrailBlazer EXT, Envoy XL, Envoy XUV)  .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals