LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Transfer Case - NVG 226-NP8) >> Repair Instructions >> Transfer Case Fluid Replacement (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transfer Case Drain Plug
    GM660282Courtesy of GENERAL MOTORS CORP.
  1. Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the drain plug threads.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the drain plug.

    Tighten:  Tighten the plug to 27 N.m (20 lb ft).

  3. Fill the transfer case with the proper fluid. Refer to Capacities - Approximate Fluid  .
    4. Fig 2: View Of Transfer Case Fill Plug
    GM660281Courtesy of GENERAL MOTORS CORP.
  4. Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the fill plug threads.
  5. Install the fill plug.

    Tighten:  Tighten the plug to 27 N.m (20 lb ft).

  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement in Frame and Underbody.
  7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals