LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Transfer Case - NVG 226-NP8) >> Repair Instructions >> Transfer Case Adapter Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Transfer Case Assembly From Vehicle
    GM747095Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the transfer case assembly from the vehicle. Refer to Transfer Case Assembly Replacement (TrailBlazer, Envoy)  .
    3. Fig 2: View Of Transmission Mount Bolts
    GM747102Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The transmission mount DOES NOT have to be removed to perform the following service procedure.
  3. Remove the transmission mount bolts.
    4. Fig 3: Installing Transmission Jack Under Transmission
    GM747100Courtesy of GENERAL MOTORS CORP.
  4. Install a transmission jack under the transmission.
  5. Lift the transmission just high enough to remove the transfer case adapter.
    6. Fig 4: Removing Transfer Case Adapter Mounting Bolts
    GM746675Courtesy of GENERAL MOTORS CORP.
  6. Remove the transfer case adapter mounting bolts from the transmission.
    7. Fig 5: Removing Transfer Case Adapter
    GM747108Courtesy of GENERAL MOTORS CORP.
  7. Remove the transfer case adapter from the transmission.
    8. Fig 6: Removing/Installing Transfer Case Adapter Seal
    GM746674Courtesy of GENERAL MOTORS CORP.
  8. Remove the transfer case adapter seal.
scientia non olet · About LEMON Manuals