LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Transfer Case - NVG 226-NP8) >> Repair Instructions >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Transfer Case Adapter Seal
    GM746674Courtesy of GENERAL MOTORS CORP.
  1. Install the new seal on the transfer case adapter.
  2. Install the transfer adapter to the transmission.
    3. Fig 2: Installing Transfer Case Adapter Mounting Bolts
    GM709158Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the transfer case adapter mounting bolts to the transmission.

    Tighten:  Tighten the bolts to 47 N.m (35 lb ft).

    4. Fig 3: View Of Transmission Mount Bolts
    GM747102Courtesy of GENERAL MOTORS CORP.
  4. Lower the transmission to install the transmission mount bolts.
  5. Install the transmission mount bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  6. Remove the transmission jack.
  7. Install the transfer case assembly to the vehicle. Refer to Transfer Case Assembly Replacement (TrailBlazer, Envoy)  .
  8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals