Installation Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Transfer Case Right Rear Speed Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the transfer case right rear speed sensor.
Tighten: Tighten the sensor to 17 N.m (13 lb ft).
Install the transfer case right rear speed sensor electrical connector.
Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.