Installation Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying VSS Sensor Location

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the transfer case front speed sensor.
Tighten: Tighten the sensor to 17 N.m (13 lb ft).

Fig 2: View Of Transfer Case Front Speed Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the transfer case front speed sensor electrical connector.
Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.