LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1434 (Transfer Case - NVG 126-NP4) >> Repair Instructions >> Transfer Case Shift Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Transfer Case Control Module
    GM1442999Courtesy of GENERAL MOTORS CORP.
  1. Install the transfer case control module (1) to the mounting bracket.
  2. Connect the three electrical connectors to the transfer case control module.
  3. Install the transfer case control module and mounting bracket to the instrument panel mag beam.
    4. Fig 2: Removing/Installing Closeout/Insulator Panel - Left
    GM712800Courtesy of GENERAL MOTORS CORP.
  4. Install the left side closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel Gages and Console.
    5. Fig 3: Locating Access Panel
    GM752114Courtesy of GENERAL MOTORS CORP.
  5. Install the access panel.
  6. Program the transfer case shift control module. Refer to Transfer Case Control Module Reprogramming .
scientia non olet · About LEMON Manuals