LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1434 (Transfer Case - NVG 126-NP4) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Output Shaft Bushing
    GM801307Courtesy of GENERAL MOTORS CORP.
  1. Using the J 45380  , install a NEW output shaft bushing. See Special Tools and Equipment .
    1. Install the bushing or the finger section of the J 45380  . See Special Tools and Equipment .
    2. Install the finger section to the main body of the J 45380  . See Special Tools and Equipment .
    3. Position the bushing and tool to the case.
    4. Using a hammer and the J 45380  , install the bushing. See Special Tools and Equipment .
    2. Fig 2: Aligning Rear Output Shaft Seal
    GM765971Courtesy of GENERAL MOTORS CORP.
  2. Align the rear output shaft seal.
    3. Fig 3: Installing Rear Output Shaft Seal
    GM747111Courtesy of GENERAL MOTORS CORP.
  3. Using the J 37668-A  , install the rear output shaft seal. See Special Tools and Equipment .
    4. Fig 4: Location Of Drive Shaft
    GM746665Courtesy of GENERAL MOTORS CORP.
  4. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft.
  5. Inspect the transfer case fluid level. Refer to Transfer Case Fluid Replacement (TrailBlazer, Envoy, Rainier, Bravada) or Transfer Case Fluid Replacement (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  6. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals