LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1434 (Transfer Case - NVG 126-NP4) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Removing/Installing Front Propeller Shaft
    GM746668Courtesy of GENERAL MOTORS CORP.
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
    3. Fig 2: Removing/Installing Dust Shield From Front Output Shaft
    GM747076Courtesy of GENERAL MOTORS CORP.
  3. Remove the dust shield from the front output shaft.
    4. Fig 3: Inserting Screwdriver Between Front Output Shaft Seal Outer Lip & Transfer Case
    GM749437Courtesy of GENERAL MOTORS CORP.
  4. Lightly tap the screw driver around the edge of the front output shaft seal.
    5. Fig 4: Inserting Small Pry Bar Into Inner Race
    GM749435Courtesy of GENERAL MOTORS CORP.
  5. Pry the front out shaft seal from the transfer case.
    6. Fig 5: Removing Outer Part Of Seal
    GM749438Courtesy of GENERAL MOTORS CORP.
  6. Remove the front output shaft seal from the transfer case.
scientia non olet · About LEMON Manuals