LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1434 (Transfer Case - NVG 126-NP4) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing J 45236 On Front Output Shaft
    GM765966Courtesy of GENERAL MOTORS CORP.
  1. Install the J 45236  on the front output shaft. See Special Tools and Equipment .
    2. Fig 2: Aligning Front Output Shaft Seal
    GM765968Courtesy of GENERAL MOTORS CORP.
  2. Align the front output shaft seal on the J 45236-2 (1).
  3. Using the J 45236-1 (2), install the front output shaft seal.
  4. Remove the J 45236-1 and the J 45236-2.
    5. Fig 3: Removing/Installing Dust Shield From Front Output Shaft
    GM747076Courtesy of GENERAL MOTORS CORP.
  5. Install the dust shield on the front output shaft.
    6. Fig 4: Removing/Installing Front Propeller Shaft
    GM746668Courtesy of GENERAL MOTORS CORP.
  6. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  7. Inspect the transfer case fluid level. Refer to Transfer Case Fluid Replacement  .
  8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals