LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1434 (Transfer Case - NVG 126-NP4) >> Repair Instructions >> Transfer Case Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Aligning Input Shaft Seal On Input Shaft
    GM747110Courtesy of GENERAL MOTORS CORP.
  1. Align the input shaft seal on the input shaft.
  2. Using the J 42738  , install the input shaft seal. See Special Tools and Equipment .
  3. Install the transfer case assembly. Refer to Transfer Case Assembly Replacement (TrailBlazer, Envoy) .
  4. Inspect the transfer case fluid level. Refer to Transfer Case Fluid Replacement (TrailBlazer, Envoy, Rainier, Bravada) or Transfer Case Fluid Replacement (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals