LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1434 (Transfer Case - NVG 126-NP4) >> Repair Instructions >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Oldsmobile Bravada and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Transfer Case Adapter Seal
    GM746674Courtesy of GENERAL MOTORS CORP.
  1. Install the new seal on the transfer case adapter.
  2. Install the transfer adapter to the transmission.
    3. Fig 2: Installing Transfer Case Adapter Mounting Bolts
    GM709158Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the transfer case adapter mounting bolts to the transmission.

    Tighten:  Tighten the bolts to 47 N.m (35 lb ft).

    4. Fig 3: View Of Transmission Mount Bolts
    GM747102Courtesy of GENERAL MOTORS CORP.
  4. Lower the transmission to install the transmission mount bolts.
  5. Install the transmission mount bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  6. Remove the transmission jack.
  7. Install the transfer case assembly to the vehicle. Refer to Transfer Case Assembly Replacement  .
  8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals