Scan Tool Data Definitions
- ATC Application
-
The scan tool displays a numeric value. This parameter indicates the model number assigned to the transfer case.
- ATC Software ID
-
The scan tool displays a alphanumeric value. This parameter indicates the numbers or characters assigned to the current version of software used in the transfer case shift control module.
- Battery Voltage
-
The scan tool displays a range of 0-25.5 volts. This parameter indicates the voltage measured by the transfer case shift control module at the transfer case shift control module battery feed.
- Current Slip Adapts
-
The scan tool displays a numeric value. This parameter indicates corrective adjustments made by the transfer case shift control module for wheel slip events.
- Front Propshaft Speed
-
The scan tool displays a range of 0-8,192 RPM. This parameter indicates the rotational speed of the front propshaft.
- Ignition Cycles Since Last Current DTC
-
The scan tool displays a numeric value. This parameter indicates how many ignition cycles have occurred since last current DTC was set.
- Motor A Current
-
The scan tool displays Amps. This parameter indicates current flow when the motor moves one of two directions.
- Motor B Current
-
The scan tool displays Amps. This parameter indicates current flow when the motor moves one of two directions.
- Rear Propshaft Speed
-
The scan tool displays a range of 0-8,192 RPM. This parameter indicates the rotational speed of the rear propshaft.
- Service 4WD Lamp
-
The scan tool displays ON or OFF. This parameter indicates On when the transfer case shift control module commands the Service 4WD Lamp, or message, On.
- Slip Adapt PWM
-
The scan tool displays a range of 0-100 percent. This parameter indicates the duty cycle applied to the transfer case encoder motor.
- Total Slippage
-
The scan tool displays a range of 0-8,192 RPM. This parameter indicates the total slippage of both the front and rear propshafts.