LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Wiper System & Washer System) >> Repair Instructions >> Wiper/Washer Switch Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Wiper/Washer Switch - Rear
    GM651277Courtesy of GENERAL MOTORS CORP.
  1. Position the switch to the trim plate.
  2. Connect the electrical connector to the wiper washer switch.
  3. Install the switch to the instrument panel trim plate, ensuring that the locking tabs are properly seated.
  4. Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC) or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile/Buick) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals