LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Wiper System & Washer System) >> Repair Instructions >> Wiper Park Replacement - Rear (TrailBlazer, Envoy) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Wiper Arm Park Ramp - Rear (TrailBlazer, Envoy)
    GM751298Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper arm park ramp to the vehicle.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 2 bolts retaining the wiper arm park ramp to the lift gate.

    Tighten:  Tighten the 2 bolts to 9 N.m (79 lb in).

  4. Install the lift gate interior trim panel. refer to Trim Panel Replacement - Liftgate (TrailBlazer, Envoy, Bravada) or Trim Panel Replacement - Liftgate (TrailBlazer EXT, Envoy XL) in Body Rear End.