LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Replacement - Rear (XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper motor (1) to the endgate (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 bolts retaining the motor to the endgate.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

  3. Install the nuts.

    Tighten:  Tighten the nuts to 8 N.m (71 lb in).

  4. Connect the wiper motor electrical connector.
  5. Install the rear endgate window. Refer to Window Replacement - Endgate in Body Rear End.
  6. Install the interior trim panel to the endgate. Refer to Trim Panel Replacement - Endgate (Envoy XUV) in Body Rear End.
    7. Fig 1: Removing/Installing Weather Strip At Wiper Motor Pivot Shaft
    GM1316861Courtesy of GENERAL MOTORS CORP.
  7. Install the spacer (2) on the wiper motor pivot shaft (3).
    8. Fig 2: Locating Rear Washer Hose Connection - Liftgate (XUV)
    GM1316864Courtesy of GENERAL MOTORS CORP.
  8. Install the wiper arm (3). Refer to Wiper Arm Replacement - Rear (TrailBlazer, Envoy)  or Wiper Arm Replacement - Rear (XUV) .
  9. Inspect the rear wiper system.
scientia non olet · About LEMON Manuals