LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Wiper System & Washer System) >> Repair Instructions >> Washer Hose Replacement - Rear (TrailBlazer, Envoy) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the washer hose to the vehicle.
  2. Route the hose along the body wiring harness.
  3. Tape the washer hose to the body wiring harness with 3 wraps of electrical tape, every 100 mm (4 in).
  4. Roll the carpet back into place along the floor panel.
  5. Install the rear compartment anchors.
  6. Install the rear seat backs.
  7. Install the right front sill plate. Refer to Door Sill Plate Replacement - Rear (TrailBlazer, Envoy, Bravada) or Door Sill Plate Replacement - Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) in Interior Trim.
    8. Fig 1: Identifying Wiring Harness Pass Through Boot To Liftgate
    GM749976Courtesy of GENERAL MOTORS CORP.
  8. Connect the washer hose connection at the lift gate.
  9. Connect the pass-through grommet the lift gate.
  10. Install the left rear quarter upper trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper (TrailBlazer, Envoy, Bravada) in Interior Trim.
    11. Fig 2: Locating Rear Washer Hose Connection, Near Coolant Tank (TrailBlazer, Envoy)
    GM751308Courtesy of GENERAL MOTORS CORP.
  11. Install the rear washer hose out through the bulkhead, and seat the grommet (1).
  12. Connect the rear washer hose connection (2) near the coolant tank.
scientia non olet · About LEMON Manuals