LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Wiper System & Washer System) >> Repair Instructions >> Washer Hose Replacement - Liftgate (XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the rear washer hose along the wiring harness.
  2. Tape the rear washer hose to the wiring harness with 3 wraps of electrical tape at points no more than 100 mm (4 in) apart from each other.
  3. Install the end gate wiring harness to the end gate. Refer to Wiring Harness Replacement - Endgate in Body Rear End.
    4. Fig 1: Locating Rear Washer Hose Connection (TrailBlazer, Envoy)
    GM751300Courtesy of GENERAL MOTORS CORP.
  4. Install the rear washer hose and grommet to the end gate outer panel.
  5. Install the end gate interior trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) in Interior Trim.
    6. Fig 2: Locating Rear Washer Hose Connection - Liftgate (XUV)
    GM1316864Courtesy of GENERAL MOTORS CORP.
  6. Connect the rear wiper hose connection (1) at the end gate outer panel.
scientia non olet · About LEMON Manuals