LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Wiper System & Washer System) >> Repair Instructions >> Washer Hose Replacement - Liftgate (TrailBlazer, Envoy) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the rear washer hose along the wiring harness.
  2. Tape the rear washer hose to the wiring harness with 3 wraps of electrical tape at points no more than 100 mm (4 in) apart from each other.
  3. Install the liftgate wiring harness to the liftgate. Refer to Wiring Harness Replacement - Liftgate in Body Rear End.
    4. Fig 1: Locating Rear Washer Hose Connection (TrailBlazer, Envoy)
    GM751300Courtesy of GENERAL MOTORS CORP.
  4. Position the rear washer hose and grommet to the liftgate outer panel.
  5. Install the liftgate interior trim panel. Refer to Trim Panel Replacement - Liftgate (TrailBlazer, Envoy, Bravada) or Trim Panel Replacement - Liftgate (TrailBlazer EXT, Envoy XL) in Interior Trim.
    6. Fig 2: View Of Rear Wiper
    GM751295Courtesy of GENERAL MOTORS CORP.
  6. Connect the rear wiper hose connection (4) at the liftgate outer panel.
scientia non olet · About LEMON Manuals