LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Wipers Inoperative - All Modes

Wipers Inoperative - All Modes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Wipers Inoperative - All Modes Diagnostic Test

Step Action Yes No
Schematic Reference: Wiper/Washer System Schematics 
Connector End View Reference: Wiper/Washer System Connector End Views 
DEFINITION: Windshield wipers are inoperative in all modes.
1 Did you perform the Wiper/Washer Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Wiper/Washer 
2
  1. Turn ON the ignition.
  2. Attempt to operate the windshield wipers in all modes.
Are the windshield wipers inoperative in all modes?
Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3
  1. Turn OFF the ignition.
  2. Disconnect the windshield wiper motor connector.
  3. Turn ON the ignition.
  4. Connect a test lamp between the accessory voltage supply circuit terminal and the ground circuit terminal of windshield wiper motor in the windshield wiper motor harness connector.
Does the test lamp illuminate?
Go to Step 5  Go to Step 4 
4 Connect a test lamp from the accessory voltage supply circuit terminal in the windshield wiper motor harness connector to a good ground.
Does the test lamp illuminate?
Go to Step 7  Go to Step 6 
5 Inspect for poor connections at the windshield wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
6 Repair an open or short to ground in the accessory voltage supply circuit to the windshield wiper motor. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Is the repair complete?
Go to Step 9  -
7 Repair an open or high resistance in the windshield wiper motor ground circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Is the repair complete?
Go to Step 9  -
8 Replace the windshield wiper motor. Refer to Wiper Transmission Replacement .
Is the repair complete?
Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3