LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Seat Belt Side Buckle Replacement - Rear (TrailBlazer, Envoy, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the rear seats and seat backs to a cargo position.
  2. Loosen the center seat belt anchor bolt that retains the seat belt to the seat belt buckle/anchor plate assembly.
    3. Fig 1: Removing/Installing Seat Belt Side Buckle - Rear
    GM753725Courtesy of GENERAL MOTORS CORP.
  3. Remove the left rear seat back rear mounting nut that retains the left seat back to the floor panel.
  4. Remove the assembly clip that retains the seat belt buckle/anchor plate assembly to the rear seat back hinge bracket.
  5. Remove the seat belt buckle and anchor plate assembly from the rear seat back hinge bracket.
  6. Remove the center seat belt anchor bolt from the seat belt buckle/anchor plate assembly.
  7. Remove the center seat belt anchor from the seat belt buckle/anchor plate assembly.
scientia non olet · About LEMON Manuals