Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Seat Belt Side Buckle - Rear

Courtesy of GENERAL MOTORS CORP.

IMPORTANT:

When installing the center seat belt anchor to the seat belt buckle/anchor plate assembly, ensure that the center seat belt webbing is not twisted.
Ensure that the center seat belt anchor is properly indexed between the locating tangs on the seat belt buckle/anchor plate assembly.

Position the center seat belt anchor to the seat belt buckle and anchor plate assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the center seat belt anchor bolt that retains the center seat belt anchor to the seat belt buckle/anchor plate assembly. Tighten the bolt finger tight.
Position the seat belt buckle/anchor plate assembly to the rear seat back hinge bracket.
Install the left rear seat back rear mounting nut that retains the left seat back to the floor panel.
Tighten:
- Tighten the rear seat back rear mounting nut to 45 N.m (33 lb ft).
- Tighten the center seat belt anchor bolt to 50 N.m (37 lb ft).
Return the rear seats to the passenger position.