LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Seat Belt Side Buckle Replacement - Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Seat Belt Side Buckle - Rear
    GM831437Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the seat belt side buckle (1) to the seat with the seat belt anchor nut (2).

    Tighten:  Tighten the seat belt side buckle nut to 55 N.m (40 lb ft).

    2. Fig 2: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
  2. Install the inboard rear seat back cushion latch cover with 3 screws.

    Tighten:  Tighten the rear seat back cushion latch cover screws to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals