LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 2 Left Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat belt retractor assembly to the vehicle.
    Fig 1: Removing/Installing Seat Belt Retractor Assembly - No. 2 Left Rear
    GM830745Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat belt retractor assembly to the vehicle.

    Tighten:  Tighten the rear seat belt retractor bolts to 70 N.m (52 lb ft).

  3. Install the left rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter - Left (TrailBlazer, Envoy, Bravada) or Trim Panel Replacement - Rear Quarter - Left (TrailBlazer EXT, Envoy XL) in Interior Trim.
  4. Install the rear seat belt lower anchor nut. Ensure that the seat belt webbing is not twisted.

    Tighten:  Tighten the rear seat mounting nut to 45 N.m (33 lb ft).

  5. Install the rear seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.

    Tighten:  Tighten the bolt to 70 N.m (52 lb ft).

scientia non olet · About LEMON Manuals